GODIAG OBD2 Jumper Cable is designed for replacing cables connecting different ECUs and devices via OBD2 way like MMPS, FGTECH, KESSV2, BYSHUT, DISPROG, etc.
Functions:
- Supports DC power supply
- Support safety protection banana head super programming dedicated connection port power supply.
- Independent GND4, GND5 [for special ECU programming].
- With boot GND4 clip, compatible with programming equipment such as MPPS, FGTECH, KESSV2.
- With GND4 GND5 short-circuit switch [For ECUs needed to be switched to short-circuit mode when programming].
(Note: The switch of GND4-5 is normally pressed to make it light. When some ECUs need to be independently connected to GND4 and GND5, release the switch)
- Simulate ignition switch [equipped with 1 large and 2 small dedicated ignition cables].
- Support standard obd2 full protocol connection [double K line, double CAN line], 3 large and 2 small power plugs, 4 large GND, 4 small GND.
- Equipped with CAN protocol communication resistance.
- Breakout Tricore Cable
- Replace EIS/ELV Test Lines(Full package 74EUR), working with Xhorse, CGDI, IM608series products to read eis data for key matching.
Supported Ports:
BMW 20
BENZ38
PSA-
DAIHATSU-4
FIAT-3
GAZ
NISSAN-14
SUZUKI-3
AUDI 4
BENZ 1
CHRYSLER 6
DAEWOO 12
FORD6+1
GM12
HONDA3
KIA20
MAZDA17
MITSUBISHI 12
SSANGYONG 20
SUBARU 9
TOYOTA 17
TOYOTA 22
BENZ 8
BENZ OD1 16
Connections to different devices:
With Xhorse Key Tool Plus,
With FGTECH,
With MPPS,
With Kess V2,
Our Tests:
1)Work with MPM to read Cadillac, 2.0L, L4 E67 Gen4
2)Work with MPM, GT105 for Chevy Engine ECU chip tuning
3)Work with OBDSTAR P50 for Nissan Airbag Reset
Customer Tests:
1)Work with VVDI MB to read W221 EIS.
(Need a 120ohm resistor between CAN-H & CAN-L, but double CAN line, very well)
2)Work with VVDI2 to read Audi Simos 6.2 6.3 Pin code and flash data.
More functions to be explored!
https://www.cardiagtool.co.uk/
Email:sales@cardiagtool.co.uk
Whatsapp: +86 15002705698