With ThinkDiag OBD2 full system code reader, it’s easier to reset steering angle sensor on your car by yourself. Only takes a few minutes!
Check the guide to reset SAS in different methods.
What you need:
Device: Thinkcar Thinkdiag OBD2 Bluetooth diagnostic tool
Src: http://www.cardiagtool.co.uk/launch-thinkdiag-obd2-code-scanner.html
Car: 2015 Chevy Suburban/ 2017 Chevy Silverado
Note: Please use the car model which is supported by Launch ThinkDiag. You’d better check whether your car can work with Thinkdiag before purchasing. You can visit the official website to search: https://mythinkcar.com/coverage/checklist or ask your dealer.
Two methods to reset steering angle sensor by ThinkDiag:
Plug the ThinkDiag device into OBDII port in your vehicle
Note: It indicates that the device powers on when the green light appears
Turn the ignition on
Run ThinkDiag APP
Method 1:
Select ThinkStore-> Purchased software-> select the corresponding car brand-GM
It will connect Bluetooth automatically
Tap Automatically Search to read VIN
It will ask you to turn on the ignition. If has turned on, just click OK to continue
Read out vehicle info incl. VIN, car year, make, model, type, source and engine identifier
Select System Selection->Electronic Brake control module (EBCM)->Read Fault Code-> DTC Display
The error of steering wheel angle shows on the screen
Back to System Menu
Select Steering Wheel Angle Sensor Module (SWASM)->Special functions->Steering Wheel Angle Sensor Learn
Then follow the prompts on-screen to turn the ignition off and then turn on
Procedure complete
Back to System Menu to select Electronic Brake control module (EBCM) -> Clear Fault Code
Read fault code again
Now there is not trouble code, system is normal.
Method 2:
Go to ThinkStore-> Purchased software-> RESET SAS
Select the corresponding car manufacturer-GM
Follow the prompt to turn on ignition
Pay attention to path to enter GM software
Select car model and car year: Chevrolet-> Silverado-> 2016-2018
Detect car year successfully
Confirm to reset steering angle sensor
Refer to service manual for instructions
Turn on ignition and then turn off, turn on again
Finish resetting steering angle sensor
That’s all!