kess V2 Master Ksuite V2.3.2 FW4.036 Download at Mega (ok on XP win7 8 10)

Ksuite V2.3.2 is tested ok on kess V2 master FW4.036 and available download at mega. It is tested ok on XP win7 win8 win 10.

ksuite 2.32

Ksuite V2.3.2 download link:

https://mega.nz/#!tJJDgLBA!YUWWS9rYKf7usCjudk2dgve_xrxS9ePes0xIt-XjgZ4

Crack

No password

XP win7 win8 win 10 all OK

Who tested Ksuite V2.3.2?

www.cardiagtool.co.uk engineer tested it working 100% OK and would like to share public.

Test report:

Car – OK

Motorcycle – Fail, better use Fgtech V54 (for the difference between FGTECH and KESS, skip to the last paragraph.)

Update – not allowed

Connect network – Not allowed, please disconnect the network before you install the software or use the device.

The compatible Kess V2 master V4.036 hardware:

(Best quality) se87-c, €89:

http://www.cardiagtool.co.uk/v211-kess-v2-firmware-v4036-perfect-version.html

se87-k, €64:

http://www.cardiagtool.co.uk/kess-v2-truck-version-manager-tuning-kit-master-version.html

se87-ck, €65: http://www.cardiagtool.co.uk/new-truck-version-kess-v2.html

Here se87-c PCB

se87-c-kess-v2-c-pcb-board

Review on the differences of MPPS, Kess, Fgtech and ktag-trasdata:

  1. Kess (even china good clone)…more stable than Mpps on can-line and good job on recovery…mpps good job on k-line (sometimes and can-line)…fgtech (i hate this tool)-but sometimes save your as…and best ktag-trasdata-no obd but safe boot mode,pinout direct conection and bdm…i talk about low price tools.

 

  1. KESS V2 is a ECU programming tool that is perfect for OBD use, while KTag is perfect for Jtag, BDM and all the Boot application (tricore and ST10).

With KESS V2 you programming directly through the OBD port of the vehicle, while with Ktag you need to take apart the ECU and  open it, after you can make the read/write operation.

Many ECU has the advantage that can be read and write from OBD port (so KESS V2 is perfect), but there are lot ECU that need to disassemble from the car and open and this is the case for all the ECU that need to be programmed with Jtag, BDM and Boot protocols, so KTAG is needed.

Fgtech Galletto ECU programming tool is perfect for both OBD use and BDM use. Fgtech Galletto is the no tokens limitation while KESS V2 and Ktag will use tokens.

In a word, being a professional ECU tunner, you need all above-mentioned tools.