LED BDM frame with mesh & 4 pro pens User Guide (Step -by -step)

Paid one LED BDM frame with mesh & 4 pro pens to work with V5.017 KESS V2 or V7.020 KTAG ECU Programmer, but have no ideal on how to use it, you must read below user guide with step by step procedure.

Insert the probe to connect the BOOT on the ECU board and CNF1, the legend for the public MED17.5.2 computer board.

led-bdm-frame-user-guide-01

Applicable to open the ECU, to avoid welding jumper. In the acrylic board with LED light bar, help the case of poor light to see the hole of the board.

led-bdm-frame-user-guide-02

Jumper for the plug-in, to reduce the trouble of welding the connection, easy to connect, and can be more than a series.

led-bdm-frame-03

LED power situation, the whole board can see clearly. LED power supply with ECU equipment with 12V power supply, connect the probe, you can disconnect the power supply, to the equipment for the

led-bdm-frame-user-guide-03

 

The new LED light bar interface is fixed on the acrylic plate, for the straight type.

led-bdm-frame-user-guide-04

Add a LED light to facilitate the case of poor light to see the computer board, the picture on the LED lights may be updated at any time, only for more practical.

led-bdm-frame-user-guide-05

 

The tip of the probe is specially designed and scalable.

led-bdm-frame-user-guide-06

Here, this is how to get BDM frame to work with ECU programmers Ktag 7.020:

led-bdm-frame-user-guide-07

 

Done.