Finally tested ktag cloneas it is, with no rework.
Done Iveco truck EDC7U31 and Audi ME7.5.20, bothvery good, working great!
K-tag board, no rework
I’m using K-TAG sw v2.10 hw v5.001
Tested on Iveco truck EDC7U31:
Go to Truck-> Iveco truck-> Cursor B-> Bosch EDC7UC31 to read the ecu data
Ktag 2.10 read EDC7UC31 successfully, with disassembling the ecu
about 5 minutes to complete the ecu reading
Tested on Audi ME7.5:
ME7 boot pin
ME7 pin out
Pin 3,62 – red – +12V
Pin 2 – black – ground
Pin 43 – yellow – K-Line
Soldered wire – gray with alligator clip – BOOT
ME7 Protol selection
Select BOOTLOADER ST 10FXXX>>BOSCH ME7.5 VAG HW II
ME7.5 full files
ME7.5 full read
Success! Read ME7.5 with K-tag master, everything good !
And i found there is problem with Ktag while selecting cars family:
If i try to read with cars family, it won’t read;
But, if i select Protocol and get the correct family. it read perfectly well!
Happy with the ktag programmer!